 |
 |
 FAQ Forum Help Official CCS Support  Search
 Register
 Profile  Log in to check your private messages  Log in
|
CCS does not monitor this forum on a regular basis. Please do not post bug reports on this forum. Send them to CCS Technical Support |
| Search found 3 matches |
| Author | Message |
|---|---|
 Topic: writing and reading float to eeprom |
|
| group9 Replies: 1 Views: 3783 |
 Forum: General CCS C Discussion Posted: Wed May 02, 2007 9:07 am Subject: writing and reading float to eeprom |
| hello
i am trying to write and read some float values to the 16f877a internal eeprom. and it does not seem to work. iread some junk values back if anyone could help that would be great. thx CC ... |
|
| Topic: pullup resistors set on high |
|
| group9 Replies: 1 Views: 4203 |
Forum: General CCS C Discussion Posted: Fri Mar 16, 2007 11:33 pm Subject: pullup resistors set on high |
| hello
i have one input (to my device acting like a chip select wich can be any general I/O )that has an internal pull-up resistor and should be left open (tri-stated by the microcontroller). i don' ... |
|
| Topic: SPI interfacing CC1000 |
|
| group9 Replies: 4 Views: 9353 |
Forum: General CCS C Discussion Posted: Thu Dec 07, 2006 2:39 pm Subject: SPI interfacing CC1000 |
| i was wandering if anyone has any idea how the SPI interfacing CC1000(chipcon) is done. i am trying to convert the IAR to CCS. i don't know if the interfacing is done by just connectint the pin to th ... | |
All times are GMT - 6 Hours |
Powered by phpBB © 2001, 2005 phpBB Group