Search found 9 matches

I don't know about CCS IDE. My copy of CCS is quite old, which I bought back in 2003. I don't think they had CCS IDE back then?, or you had to avoid using TRIS. All I know is its PCM Software.

Funny you should mention that. I did use the menu Project --> Project Wizard. I just checked it again, and can't see any mention of the fuses??? I can only find it in menu configure --> configur ...

Many thanks for all your advice.
Yes my scope is fast enough, thanks for pointing that out.
You are correct, I did have tris_b set to 0xff, which was a silly mistake. That happened as I was origina ...

I have been writing code in ASM which all works fine, and now writing the same code using CCS, however I'm having trouble with the basics of simply toggling portb output pins.

When I monitor the sp ...

This is a little off topic, but I wanted to make this information available online to hopefully prevent other students having a simular problem.

I contacted CCS regarding the student version, this ...

Is that a new thing? I'm sure I didn't see that when I purchased the software mid december last year?

Well hopefully my humble views will not drive CCS into changing their business structure into catastrophic failure within this niche market.

I totally agree with your comments, CCS is a business an ...

Well I�ll keep a close eye on this discussion and see what other peoples views are as well. If most people are in agreement, then maybe we should all stand together and make our voices heard to CCS. A ...

This is very odd, my code works fine, but just by adding the line

if (data_rx < 0x41) data_rx = 0x41; //capping

I get the error message
---------------------------
MPLAB IDE
------ ...